Hall -> VR

[NiceMan]

Onko jossain listaa mitä pitää jumpperoida mitenkin kun vaihtaa anturi mallia?
Posti toi juuri uusia VR antureita joista yksi tarkoitus saada toimimaan mega3:ssa 36-1 pyörällä.
Kun kasasin niin piirilevylle tuli kaikki tavarat kiinni .
http://riceracing.net/Gallery/displayimage.php?pid=509

[NiceMan]

Taisin löytää vastauksen.

52. Select the tach input circuit with jumpers:

For the VR sensor:

Jumper VRIN to TACHSELECT on the bottom side of the PCB (near the DB37, opposite the heat sink.)
Jumper TSEL to VROUT (Or VROUTINV if you want the VR input to be inverted) on the bottom side of the PCB, near the center.


OR (Do NOT install both sets of jumpers, chose one set or the other!)
For the Hall sensor, optical sensor, coil negative terminal or points:

Jumper XG1 to XG2 on the bottom side of the PCB, near the 40 pin socket,
Jumper OPTOIN to TACHSELECT on the bottom side of the PCB, near the DB37 connector, opposite the heat sink.
Jumper TSEL to OPTOOUT on the bottom side of the PCB, near the center.