sellainen kysymys
Posted: Sun Sep 09, 2007 19:38
sellaista varmistelen, kun olen kasannut megan v2.2 ohjeiden mukaan valmiiksi ja saanut sen testattua toimivaksi niin täytyykö siihen tehdä seuraavat muutokset että saa kipinän hoidettua bosch 0227100123 modulilla?
ajattelin ensin laittaa sytyksen ja myöhemmin bensan ohjauksen.
(Megasquirt'n'spark)
V2.2 Board mods
Old, incorrect wiring. If you did it this way you MUST change.
Remove D8 (if fitted) and install jumper.
Keep R10 as 390 ohms
Jumper XG1-XG2
New wiring confirmed by Moby:
.Remove D5,D8,R10
.Remove jumper between XG1-XG2
.Fit wire between XG1 and right of D5 (non band)
.Fit wire between bottom of R10 and small hole above D9 (this is a +5v source - you could also use the hole to the left of D4)
.Fit 1.3k resistor in place of D8 (1k-2k ok)
Add 1k resistor from (-) of D17 to the right (5v) side of R23
Run a length of wire from D17 (-) to X11
Add 1k resistor from (-) of D19 to the right (5v) side of R27.
Run a length of wire from D19 (-) to X12
ajattelin ensin laittaa sytyksen ja myöhemmin bensan ohjauksen.
(Megasquirt'n'spark)
V2.2 Board mods
Old, incorrect wiring. If you did it this way you MUST change.
Remove D8 (if fitted) and install jumper.
Keep R10 as 390 ohms
Jumper XG1-XG2
New wiring confirmed by Moby:
.Remove D5,D8,R10
.Remove jumper between XG1-XG2
.Fit wire between XG1 and right of D5 (non band)
.Fit wire between bottom of R10 and small hole above D9 (this is a +5v source - you could also use the hole to the left of D4)
.Fit 1.3k resistor in place of D8 (1k-2k ok)
Add 1k resistor from (-) of D17 to the right (5v) side of R23
Run a length of wire from D17 (-) to X11
Add 1k resistor from (-) of D19 to the right (5v) side of R27.
Run a length of wire from D19 (-) to X12